Filter
Top Products
4
Unpack the Wine Cellar
Remove the Packaging
Remove tape and glue residue from surfaces before turning
on the wine cellar. Rub a small amount of liquid dish
soap over the adhesive with your fingers. Wipe with warm
water and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your wine cellar.
For more information, see “Wine Cellar Safety.”
Dispose of/recycle all packaging materials.
Clean Before Using
After you remove all of the packaging materials, clean the inside
of your wine cellar before using it. See the cleaning
instructions in “Wine Cellar Care.”
Wine Cellar Door
IMPORTANT: All graphics referenced in the following instructions
are included later in this section after “Final Steps.” The graphics
shown are for a right-hand swing door (hinges factory installed on
the right).
Remove Door and Hinge
1. Unplug wine cellar or disconnect power.
2. Place the wine cellar on its back.
3. Remove the bottom right leveling leg. See Graphic 4.
4. Remove the the screws from the lower hinge assembly. See
Graphic 3.
5. Pull the door downward to remove it from the cabinet of the
wine cellar.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
wine cellar.
Failure to do so can result in back or other injury.
When Moving Your Wine Cellar:
Your wine cellar is heavy. When moving the appliance
for cleaning and service, be sure to protect the floor. Always
pull the appliance straight out when moving it. Do not
wiggle or “walk” the appliance when trying to move it, as
floor damage could occur.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
wine cellar.
Failure to do so can result in back or other injury.