Filter
Top Products
9
General Cleaning (continued)
To Raise and Lower the Top for Cleaning
1. Remove burner grates and spillover bowls. Set aside.
2. Grasp the front of the cooktop and then lift.
3. Lift the top high enough to fully raise the support rods. The Lift-up rods will support the top in its raised position.
4. Clean underneath using hot, soapy water and a clean cloth; then dry.
5. Lower the top gently after lowering the support rod.
When lowering the top, grasp the sides with fingertips only. Be careful not to pinch fingers. Also, DO NOT drop
or bend the cooktop when raising or lowering. This could damage the surface.
DO NOT turn the burners on when the cooktop is raised for cleaning. Be sure that the top is completely lowered
and securely in place before turning on the burners.
To Remove and Replace Burners for Cleaning
Your model will have one of the two burners types shown below. Follow the instructions that correspond with the burners on your
cooktop.
To Remove Burners (Figure 1)
1. Remove shipping screws with a Phillips® Head screwdriver. See illustration for screw locations.
2. Tilt the burner at the end closest to the support bar until the locator tab is released (front burners tilt right, rear burners tilt left).
Move it toward the back of the cooktop. This will separate it from the gas valve at the front of the cooktop.
To Remove Burners (Figure 2)
1. Remove shipping screws with a Phillips® Head screwdriver. See illustration for screw locations.
2. Lift burner pair straight up and out.
To Replace Burners (Figure 1)
1. Slide the burner tube over the gas valve at the front of the cooktop (front burners fit over the right valve, rear burners fit over
the left valve on each side of the cooktop).
2. Tilt burner so that the locating tab will slide into the slot on the support bar. Make sure burners are properly seated on support
bar and are level.
3. Replace shipping screws if desired.
To Replace Burners (Figure 2)
1. Place burner pair over mounting bracket. Make sure burners are positioned over gas valves and are properly positioned and
level.
2. Replace shipping screws if desired.
Figure 1
Figure 2