Filter
Top Products
12
STORAGE
Wine bottles may differ in size and dimensions so the actual number of bottles can be stored may vary.
The 18 or 33 bottle capacities are approximate maximums when storing traditional Bordeaux 750 ML
bottles and includes bulk storage.
NOTE: Wine bottles on bottom shelf cannot be longer than 12 inches.
DOOR LOCK
The appliance is provided with a lock and key combination.
The keys are located inside the plastic bag that holds the Owner’s Manual. Insert the key into the lock and
turn it counterclockwise to unlock the door. To lock the door do the reverse operation making sure metal
pin is engaged completely. Remove the key and place it in a secure place..
WINE SHELVES
To prevent damaging the door gasket, make sure to have the door all the way opened when pulling the
shelves out of the rail compartment.
For easy access to the storage content, you must
pull the shelf approximately ⅓ out of the rail
compartment, however this appliance is designed
with a plastic post on each sides of the shelf track
to prevent the shelves and the bottles from
completely sliding out or falling.
When removing the shelves out of the inner rail,
make sure to remove all items first. Then move the
shelf to the position where the notch of shelf is
exactly under the plastic post and lift the shelf. In order to replace the shelves, repeat steps described
above in reverse.
HUMIDITY CONTROL
This appliance is equipped with a system for maintaining the correct level of humidity. Fill the small
plastic reservoir (humidity box) to about ¾ full with water, the place it onto the runners found on the
top shelf of the appliance. Check the water level
regularly and refill as necessary.
Please ensure the reservoir is positioned correctly on
the runners on the top shelf to avoid the possibility of
water spillage.
ACTIVE CHARCOAL FILTER
Replace the active charcoal filter with new one once a year. It can be purchased from the retailer or
Whynter’s Service Department.
To change the filter,
Turn the filter cover 90°clockwise or anti-clockwise. And then
remove the filter.
Insert the new filter in the vertical position.
Turn the filter cover 90° clockwise or anti-clockwise until it click
into position.