Filter
Top Products
5
Before you begin
Preparing the refrigerator for use before you plug the refrigerator in to a power supply, be sure to let it
stand upright for at least 24 hours to allow the compressor’s oils to settle.
Unpacking the refrigerator
Carefully remove the packaging materials. Remove any shipping tape and glue from your refrigerator
before using. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to
remove tape or glue. These products can damage the surface of your refrigerator. If any parts are
missing, please contact our customer service. Put the refrigerator on a level and flat surface and away
from direct sunlight and other sources of heat such as a stove, furnace, radiator, etc. The appliance
must be positioned so that the power plug is accessible.
Before using your refrigerator, you are strongly recommended to clean it thoroughly. (This
process should clean the unit of any impurities that may have been left behind during the manufacturing
process.)
1. Clean the interior with a diluted cleaning solution, warm water and a soft cloth. (DO NOT use any
caustic or abrasive solutions) (Do not clean your refrigerator with flammable fluids.)
2. The outside of the refrigerator should be cleaned regularly with a mild detergent and warm water.
3. Dry the interior and exterior with a soft cloth.
REQUIREMENTS
Installation Requirements
The refrigerator has been designed for free-standing installation which will allow you to install the unit in
almost any place you desire. Please make sure to follow the instructions for clearance, water and
electrical requirements.
Clearance and Environment Requirements
Choose a well-ventilated area with temperatures above 50°F and below 90°F. Operation
outside these temperatures may result in lowered production or may cause other adverse
effects.
This unit must be installed in an area protected from the elements, e.g., wind, rain, water spray
or drips. The refrigerator should not be located next to ovens, grills or other high heat sources.
The unit should be located on a firm and level surface that is able to support the refrigerator’s
total weight with water.
There must be at least 4 inches of space around the back and sides of the unit for proper air
circulation.
If you are installing your refrigerator next to a fixed wall, leave sufficient space on the hinge side
to allow for the door to swing open.
Electrical Requirements
Read all safety precautions listed at the beginning of this manual. It is recommended that a separate
circuit serving only your refrigerator be provided. Use receptacles that cannot be turned off by a switch
or pull chain.
The refrigerator is equipped with a power supply cord having a 3-prong grounding plug. To minimize
possible shock hazard, the cord must be plugged into a mating 3-pronged and grounding-type wall
Do not remove any safety, warning, or product information labels from your refrigerator.
Use two or more people to move refrigerator. Failure to do so can result in back or other injury