Wolf Downdraft Ventilation Ventilation Hood User Manual


 
9
Protective Polish:
Apply to the surface to
maintain luster and protect from some food
s
tains. Use a soft, non-abrasive stainless steel
cleaner like Signature Polish (see side note)
and apply with a soft lint-free cloth.
F
ILTER
C
ARE
The aluminum mesh filters should be cleaned
approximately every month, depending on
use. The FILTER clean LED on your control
module will illuminate when it is time to clean
the filters. This indicator light comes on after
approximately 30 hours of operation. You may
need to clean the filters more often if your
cooking style generates large amounts of
grease, like frying foods or wok cooking.
The filters and filter covers are dishwasher
safe and are designed to fit most dishwashers.
To remove the filters, push down on the filter
frame while pulling the filter out away from
the downdraft. Refer to the illustration below.
Place the aluminum mesh filter and stainless
steel cover into the dishwasher at approxi-
mately 140˚F (60˚C), or hand wash, and use a
biodegradable detergent. When filters are dry,
reinstall using the reverse procedure.
IMPORTANT NOTE:
DO NOT operate the
downdraft without filters. This may cause
damage to the blower or other internal
components of the downdraft system.
WOLF DOWNDRAFT USE & CARE
GENERAL CARE
Most surfaces of your downdraft ventilation
system are stainless steel or aluminum.
A
lthough these surfaces are resistant to most
stains, they are not totally impervious to
damage. Salt and some cooking liquids may
p
it and stain the surface. Always remove these
spills immediately.
IMPORTANT NOTE:
Be careful not to soak the
control module. Although they are sealed,
excessive moisture may cause damage to the
controls.
CLEANING
Using a clean cloth or sponge, wipe with warm
water and mild detergent. Rinse and dry
immediately. Apply protective polish, always
in the same direction as the grain.
IMPORTANT NOTE:
Do not use steel wool
pads or abrasive cleaners; they will perma-
nently scratch the surface.
IMPORTANT NOTE:
Painted surfaces should
be cleaned with warm water and mild deter-
gent only.
Spray Degreasers:
Removes fingerprints and
greasy spatters. Spray on a cloth and wipe the
surface. Buff dry immediately to avoid streaks.
Hard Water Stains:
Use white vinegar and
water
.
SIGNATURE
POLISH
Signature Polish
is available from
Signature Limited
Laboratory,
P. O. Box 13436,
Dayton, Ohio
45413-0436, or
call 877-376-5474
(toll free).
Downdraft filter removal