Filter
Top Products
FULL SIZE GAS CONVECTION OVENS - REMOVAL AND REPLACEMENT OF PARTS
F32700 (February 2006)Page 13 of 64
2. Remove the door switch lever.
3. Remove the lower door seal strip to expose the
mounting screws of the door assembly.
4. Remove the two (2) lower sill bolts by the lower
door shaft and the four (4) counter-sunk screws
from the lower sill.
NOTE: The door assembly is heavy and will drop
down once the last screw is removed. If removing
door assembly with-out assistance, the ignition
cable, flame sense lead and gas manifold should
also be removed to avoid damage to these
components.
5. Tilt the top of the door slightly forward and lift the
door up until the bottom of the door shaft clears
the opening in the sill.
6. Lay the door flat to prevent damage.
7. The top and bottom bearings are now accessible
for inspection and/or replacement if needed.
A. If bearings are ok, proceed to step 8.
B. If replacing the top bearing, remove the top
bearing retainer and top bearing.
C. If replacing the bottom bearing, remove it
from the door shaft or the lower sill
opening.
8. Reverse procedure to install door assembly and
check for proper adjustment as outlined under
DOOR ADJUSTMENT and DOOR SWITCH
ADJUSTMENT in SERVICE PROCEDURES
AND ADJUSTMENTS.
OVEN DOORS
(SIMULTANEOUS DOORS)
Assembly Removal
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
1. Remove the top front cover and bottom front
cover as outlined under COVERS AND PANELS.
2. Remove the door switch lever.
3. Remove the top bearing retainers and top
bearings.
4. Remove the lower door seal strip to expose the
mounting screws of the door assembly.
A. Remove the two (2) lower sill bolts by the
lower door shaft and the four (4) counter-sunk
screws from the lower sill.