Filter
Top Products
Troubleshooting Guide
Deep Fryer has no power
The unit is not plugged in Plug the unit into a 120 volt AC outlet.
The magnetic cord is not See figure 5 on Page 12 for proper
properly fastened installation of the breakaway cord.
The control panel is not See figure 3 on page 12 for proper
properly seated placement of the control panel.
Cannot Change Settings
Cannot set the temperature Ensure that the temperature is blinking
first before attempting to set.
See page 14.
You have already started the Countdown
timer. Cancel by pressing the On/Off
button and change settings.
Cannot set the countdown timer Ensure that the time is blinking first
before attempting to set. See page 13.
Oil is overflowing
Too much oil has been placed Do not exceed the MAX line as
indicated in the Fryer pot into Fryer pot.
Too much food has been placed Do not exceed the MAX line as
indicated in the frying basket in the frying basket.
Using two different oils Empty oil and clean the pot once cooled
down. Use only one type of oil in the
Fryer. See page 18, section 4.
The food is wet or covered with ice Remove excess ice crystals from the food
and dry wet foods thoroughly OR lower
the basket very slowly into the oil.
Food is not browning
Foods are excessively thick, or Try a longer cooking time.
contain a lot of water /ice
The temperature of the oil is too low Increase temperature according to the
cooking chart on page 17.
Too much food is being added Do not exceed the MAX line of the
to the basket frying basket. You can also try frying
smaller batches.
Unpleasant Odor
The oil is overused Do not use the oil more than 8 times.
Oil has been used in different foods Do not use the same oil for fish as you
do for other food items.
Recommended oil is not being used Only use oils recommended on page 18.
Recipes
21 22
2006 Deep Fryer Manual_3 11/21/06 11:01 AM Page 23