Filter
Top Products
Assembling your Deep Fryer for Use
1
Place the Deep Fryer housing on a stable,
level surface.
2
Ensure that all components of your Deep Fryer are
completely dry prior to use to avoid risk of injury
due to spattering.
3
Insert the oil pot into the Deep Fryer housing
ensuring that the front of the pot (the front is
indicated by the tap) is placed at an angle into
the housing. (See figure 1).
4
Place the Oil Pot Filter Screen into the Oil Pot.
(See figure 2).
5
Line up the control panel into the grooves
on the rear of the Deep Fryer housing. Your Deep
Fryer is equipped with a safety microswitch which
will not allow the control panel to work unless
it is properly seated into both grooves in the
housing. (See figure 3).
6
Add the appropriate amount of oil to the oil pot.
Do not fill with oil above the maximum level or
below the minimum level marked on the inside
of the Deep Fryer pot. (See figure 4).
7
Attach the Magnetic Release Power Cord into the
receptacle on the back of the housing. Only use
the approved receptacle marked TA-35P in your
unit. To attach the receptacle ensure that the nubs
on the magnetic end of the cord are on the right
side of the plug (TA-35P) in order to line up with
the plug receptacle on the Control Panel.
(See figure 5).
8
Unfold the basket handle and ensure that it is
locked into place. (See figure 6).
9
Place the basket into the basket holder inside
the pot. (See figure 7).
Using Your Deep Fryer
figure 1
figure 2
figure 3
figure 4
figure 5
figure 6
11 12
Assembling Your Fryer
Drain Tap Cap
Your Wolfgang Puck Flash Fryer is equipped with a safety drain cap.
Your drain tap cap should always be in place when using your deep fryer
or when storing oil in the tank (see figure 1). The following directions
outline the use of the drain tap.
1 Place drain tap cap on drain tap by turning counter clockwise
until tight. Always ensure that your drain tap lock is closed whenever
using your deep fryer, or when storing oil in your tank. Never unlock
the drain tap lock with the tap cap on the drain tap.
2 To remove drain tap cap first ensure that the tap lock is in the
closed position. Turn drain cap clockwise to remove (see figure 2)
and set aside.
3 Place container under tap and unlock the drain tap lock to begin
draining oil. Never drain hot oil, or while or deep fryer is plugged in.
4 Your drain tap should be washed in warm soapy water and allowed
to dry thoroughly.
Drain tap lock
Drain tap
Drain tap cap
Figure 1
Figure 2
figure 7
2006 Deep Fryer Manual_3 11/21/06 11:01 AM Page 13