Wolfgang Puck WPPSM050C Mixer User Manual


 
7 8
Thermal Protection
Your stand mixer motor is equipped with an automatic Thermal
Protection feature which will shut your motor off if it gets too hot.
Should this occur, turn the speed selector to Off, unplug the unit and
allow it to cool down. It is normal for the mixing head to become hot
after prolonged use.
Using Accessory Attachments
A number of OPTIONAL accessory attachments are available for use
with your stand mixer, including a meat grinder, pasta extruder and
slicer/shredder. See the following general instructions for assembling
and removing these.
ASSEMBLING OPTIONAL FRONT POWER HUB ATTACHMENTS
1 Ensure stand mixer is turned off and the unit is unplugged.
2 Flip the hub cover up, and then press down and hold the accessory
release tab while inserting the accessory into the hub as far as it
will go.
3 Let go of the accessory release tab and rotate the attachment
slightly left and right until you hear the locking pin click into place.
To ensure your attachment is locked into place try pulling it out
while not pressing down on the accessory release tab.
REMOVING FRONT POWER HUB ATTACHMENTS
1 Turn stand mixer off and unplug from outlet.
2 Press the attachment lock down and hold while pulling the
accessory attachment out of the hub
1
Make sure mixer is turned to OFF and
unplugged.
2
Tilt mixer head back by pulling the mixer head
locking lever up. Lift until head locks into up
position. (see figure 1).
3
Place mixing bowl into base and turn clockwise
to lock into place. (see figure 2).
4
Attach beater, whisk or dough hook by
pressing up into beater shaft as far as it will go.
Turn counterclockwise, hooking pin into grooves
on beater shaft. (see figure 3 & 4).
5
Apply upward pressure to the mixing head while
pulling the locking lever up and guide the mixer
head back down until it locks into place. Do not
let the mixing head fall down freely. Always
guide as instructed above.
6
If mixing liquid ingredients place the splash
guard over the opening of the bowl with the
opened end of the splash guard away from you.
(see figure 5).
7
Plug cord into electrical outlet. Prepare recipe
according to instructions.
8
When finished, turn speed control dial to OFF
and unplug stand mixer from outlet. Remove
splash guard (if used).
9
Pull the mixer head locking lever up to raise
mixer head. Grasp bowl, turn counterclockwise,
and lift straight up to remove. To remove beater
attachment apply upward pressure to the beater
and turn clockwise about 1/4 turn (or until it will
not turn any longer) and pull straight down.
Remove bowl by turning counterclockwise and
lift straight up.
Using Your Mixer
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
TSCDIST_Stand Mixer Manual 8/22/07 12:45 PM Page 7