Filter
Top Products
GLASS INFORMATION
1. Under no circumstances should this product be operated with missing or broken glass.
2. Do not strike or slam the glass.
3. Do not use abrasive cleaners to clean the glass.
4.
Replacement glass is available from the manufacturer and replacement should be carried out
by a qualified service person.
CLEANING
To clean the unit, first turn off controls on unit and unplug unit from power source.
To clean the glass door: remove dust with clean dry cloth or to remove finger prints and other marks
clean glass with clean damp cloth. Do not use abrasive cleaners or spray liquids on glass door surfaces.
Metal and metal painted parts should be cleaned with clean damp cloth only. Do not use abrasive
cleaners or spray liquids on this surface.
TROUBLE SHOOTING
If the heater will not operate, please check the following before seeking repair of service:
1. Check if the power cord is plugged into an electrical outlet, if not, plug in.
2. Check if electricity to the outlet is working.
3. Insure the main power switch on the lower front of the heater is switched to “on”
4. If the power button on the front of the heater is turned on but the heater is not operating, then the
safety overheat function may have been triggered. Try pressing the power button. If the heater does
not turn on, clear any obstructions from front and rear of heater that may have caused internal
overheating. Allow the heater to cool approximately 15 minutes and then press the power button
again
Note: The heater may not be operating if the thermostat is set lower than the room temperature. To begin
operation, increase the thermostat temperature for a higher heat setting.
WARNING: Wait until the unit has
completely cooled before attempting
any cleaning.
~ 10 ~