Filter
Top Products
26
EMX5016CF Owner’s Manual
Front & Rear Panels
Reference
c PHANTOM Switch and Indicator
This switch toggles phantom power on and off. The
indicator lights up when the setting is on. If you set the
switch on, the mixer supplies power to the XLR mic
input jacks on all channels (the INPUT A jacks on
channels 1 to 8, and the MIC jacks on channel pairs
9/10 to 15/16). Set this switch on when using one or
more condenser microphones.
When the switch is on, the mixer supplies DC +48V
power to pins 2 and 3 of all XLR input jacks.
• Be sure to leave this switch off if you do not need
phantom power.
• When using phantom power, do not connect any
devices other than condenser microphones to the
XLR input jacks. Other devices may be damaged
if connected to phantom power. This precaution
does not apply to balanced dynamic microphones,
however, as these will not be affected by phantom
power.
• To avoid damage to speakers, be sure to turn off
the power to the EMX itself and to any other
power amplifiers and power speakers before
switching phantom power on or off. We also rec-
ommend that you turn all output controls (channel
faders, ST Master fader, AUX1/2 faders, etc.) to
minimum settings before operating the switch, to
avoid risk of loud noises that could cause hearing
loss or device damage.
d LEVEL Meters
If the ST/AFL-PFL switch e is set to ST, these meters
show the L and R levels of the signal output from the
ST OUT jacks R. If the ST/AFL-PFL switch is set to
AFL-PFL, the meters show the levels output from the
PHONES jack S.
Note that the signal output to the ST OUT jacks is
also passed through the internal amplifier and then
output at the SPEAKERS jacks
m. Keep an eye on
the LIMITER lamps
] to ensure that the level at the
SPEAKERS jacks does not stay too high.
e ST/AFL-PFL Switch
If the switch is set to AFL-PFL ( ), the LEVEL
meters show the level of the output at the PHONES
jack prior to adjustment by the PHONES control. If the
switch is set to ST ( ), the meters show the level
output at the ST OUT jacks following adjustment by
the ST master fader.
The PFL (F, M, i) and AFL j switches select the
mix to be monitored at the PHONES jack.
f PHONES Control
Controls the level of the signal output to the PHONES
jack.
g ST SUB OUT Control
Adjusts the signal level to the ST SUB OUT jacks.
Has no effect on the output from the ST OUT and
SPEAKERS jacks.
h STANDBY Switch
This switch mutes the input to channels 1 to 8. The
switch lights up to indicate that the mute has been
turned on. Note that the mute does not work on chan-
nels 9/10 to 15/16.
When using the mixer for live performances, you can
fill in gaps in the performance by turning on the
STANDBY switch and feeding background music
from a CD player or other such device into channels
9/10 to 15/16.
i
e
f
g
h
j
l
d
k
c
NOTE
CAUTION
NOTE
NOTE
NOTE
NOTE