Filter
Top Products
Remove all packaging before positioning the
machine.
Positioning
If possible, position the machine next to a water tap
and a drain.
The dishwasher features fill and drain hoses which
can be turned either to the left or the right to suit the
installation .
Levelling
Good levelling is essential for correct closure and
sealing of the door.
When the appliance is correctly levelled, the door will
not catch on the spacers on either side of the cabinet.
If the door does not close correctly, loosen or tighten
the adjustable support feet, until the machine is
perfectly level.
Adjusting the Worktop
You can move the worktop forward or backward by 25
mm in order to align the machine with other kitchen
units.
Simply unscrew the two front retaining screws, move
the top to the required position and then retighten the
screws.
Installing and Securing the Machine Under
a Kitchen Unit (Sink-Worktop Unit)
By removing the machine's worktop, you can install it
under a close fitting sink unit or a pre-existing top, if
the dimensions of the recess correspond to those
shown in the picture.
Then proceed as follows:
Remove the machine worktop by unscrewing the two
rear retaining screws, pull from the front and slide out
the rear slots, lifting the worktop.
Insert the machine after adjusting the height and level-
ling with the adjustable feet. When inserting the
machine, ensure that the water inlet and drain hoses
are not kinked or squashed.
Caution
Once the machine has been installed, ensure that it
is easily accessible for servicing.
INSTALLATION
PIN20GB
4
IN06
IN07
820
570÷600
600
IN05
IN01
IN03