Filter
Top Products
Electrical connection
Any electrical work required to install this appliance
should be carried out by a qualified electrician or com-
petent person.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should
this safety measure not be observed.
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance
rating plate.
The appliance is supplied with a 13amp plug fitted.
In the event of having to change the fuse in the plug
supplied, a 13amp ASTA approved (BS1362) fuse
must be used.
Should the plug need to be replaced for any reason.
The wires in the mains lead are coloured in accor-
dance with the following code:
Green and Yellow : Earth
Blue : Neutral
Brown : Live
The wire coloured green and yellow must be connect-
ed to the terminal marked with the letter “E” or by the
earth symbol or coloured green and yellow.
The wire coloured blue must be connected to the ter-
minal marked “N” or coloured black.
The wire coloured brown must be connected to the
terminal marked “L” or coloured red.
Upon completion there must be no cut, or stray
strands of wire present and the cord clamp must be
secure over the outer sheath.
WARNING: A cut off plug inserted into a 13amp
socket is a serious safety (shock) hazard.
Ensure that the cut off plug is disposed of safely.
Permanent connection
In the case of a permanent connection it is necessary
that you install a double pole switch between the ap-
pliance and the electricity supply (mains), with a mini-
mum gap of 3mm between the switch contacts and a
type suitable for the required load in compliance with
the current electrical regulations.
The switch must not break the yellow and green earth
cable at any point.
PIN08GB
6
CE03