Filter
Top Products
Clock function Application
Duration To set how long the appliance must operate.
End To set when the appliance must be deactivated.
You can use Duration and End at the same
time to set the time when the appliance
must be activated and then deactivated. First
set Duration, then End.
Setting the clock functions
1.
For Duration
and End , set an oven
function and temperature. This is not nec-
essary for the Minute Minder
.
2. Press the Selection button again and again
until the indicator for the necessary clock
function flashes.
3. Press + or - to set the necessary clock
function.
The display shows the indicator for the
clock function you set. When the set time
ends, the indicator flashes and an acoustic
signal sounds for two minutes.
With the Duration
and End func-
tions, the appliance deactivates automati-
cally.
4. Press a button to stop the signal.
5. Turn the knob for the oven functions and
the knob for the temperature to the off po-
sition.
Cancelling the clock functions
1. Press the Selection button again and again
until the necessary function indicator flash-
es.
2. Press and hold the button -.
The clock function goes out after some
seconds.
Using the accessories
Warning! Refer to the Safety chapters.
Inserting the oven accessories
Put in the slide-in accessories so that the dou-
ble side edges are at the back of the oven and
point down to the bottom. Push the slide-in ac-
cessories between the guide-bars of one of the
oven levels.
The deep roasting pan and the oven shelf
have double side edges. These edges and
the shape of the guide-bars causes the anti-tilt
safety for the oven accessories.
8
www.zanussi.com