Filter
Top Products
22
Replacing the Oven Light
FO 0287
If the oven bulb needs replacing, it must comply with
the following specifications:
- Electric power: 15W,
- Electric rate: 230-240 V (50 Hz),
- Resistant to temperatures of 300°C,
- Connection type: E14.
These bulbs are available from your local Zanussi
Force Service Centre.
To replace the faulty bulb:
1. Ensure the oven is isolated from the electrical
supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the new
one.
4. Refit the glass cover.
5. Restore the electrical supply.
F
FO 0018
To clean the oven shelves and the shelf supports, soak
in warm soapy water and remove stubborn marks with
a well wetted soap impregnated pad. Rinse well and
dry with a soft cloth.
The shelf supports can be removed for easy cleaning
(see diagram). Please, ensure the retaining nuts are
secure when refitting the shelf support.
When cleaning the shelf supports, take care not
to remove the lubricating grease behind the
telescopic runners. This is meant to ensure their
good operation.
Grease Filter
To prevent a build-up of fats on the fan impellor, the
grease filter must be fitted by clipping it over the vents
in the back panel.
To clean the grease filter
When the oven has cooled down, remove the filter by
pushing the protruding tongue on the filter upward, and
wash carefully.
The grease filter should be cleaned after every use.
The filter may be washed in a dishwasher on a 65°C
wash. If the filter is heavily soiled, place the filter in a
saucepan of water with approximately 1 teaspoon of
automatic washing powder or dishwasher powder.
Bring to the boil and leave to soak for approximately 30
minutes or longer depending on the degree of soiling.
Ensure the solution does not boil over as it could mark
your hob.
Rinse filter in clear water and dry.
Remember to refit the filter before using the oven
again.
i
Oven Shelves and Shelf Supports