Filter
Top Products
30
If the door glass panel becomes
chipped or has deep scratches the
glass will be weakened and must be
replaced to prevent the possibility
of the panel shattering. Please
contact your local Service Force
Centre who will be pleased to
advise further.
To replace the outer glass
1. Holding the oven glass with both hands,
gently place the locators into the holes
of the brackets at the bottom of the
oven door.
2. Push the top of the oven glass towards
the oven door, ensuring the screw
location holes line up.
3. Hold the glass in place with one hand
and insert the cross head screws into
the location holes with the other hand.
Give the screws one turn to ensure the
glass is secure.
4. Tighten the screws positively with a
Pozidrive screwdriver before closing the
oven door.
Do not attempt to use the oven
without the glass being in place.
To clean the inner glass door
panels
Clean the inner glass door panels using a
soft cloth and hot water to which a little
washing up liquid has been added. If the
inner panel is heavily soiled, Hob Brite may
be used. Do not use abrasive cleaning
materials on the door glass. Ensure that all
parts are well rinsed and thoroughly dried
before attempting to replace the glass.
Replacing an oven light bulb
The type of bulb required is a 300°C 25 watt
small Edison Screw.
Disconnect the appliance from the
electricity supply before replacing
the bulb.
Open the door and remove the shelves to
enable easy access to the oven light
assembly. Insert a flat blade screwdriver
between the oven side and glass which
covers the bulb.
Support the glass with your hand and prise
out sufficiently to release the glass cover.
Unscrew the bulb in an anticlockwise
direction until it is possible to remove the
bulb with ease.
Fit the new bulb by turning in a clockwise
direction until it is secure. Ensuring the
indent to the flange is pointing to the rear of
the oven, replace the glass by pushing it
firmly into the hole to cover the bulb
assembly.
Replace the shelves. Restore the electricity
supply and adjust the time of day and clock
as necessary.