Filter
Top Products
31
LOCATION OF APPLIANCE
This appliance must not be installed in a bed-sitting room of volume less than 20m
3
or in a bathroom, shower
room or garage. This is a type ‘X’ appliance, it is essential that the appliance is positioned as stated below (See
Fig 1a) i.e. shelves, wall cabinets and cooker hoods must be fitted a minimum of 787mm directly above the top of
the hotplate (or greater for cooker hoods if recommended by manufacturers instructions) and 400mm above the
hotplate when fitted in line with the outside of the appliance. If the units are intended to be fitted adjacent to the
appliance but less than 400mm above the hotplate, then a minimum space of 100mm must be maintained
between the sides of the unit and the appliance (See Fig 1b). Curtains must not be fitted immediately behind the
appliance or within 150mm of the sides of the hotplate. If fitted next to or between two base units a minimum
space of 1mm must be left between each unit and the sides of the appliance. The levelling feet fitted to the
appliance will achieve a nominal height to hotplate trims of 900mm + 20mm.
Note:- L.P.G. cookers MUST NOT be installed below ground level i.e. in a basement or aboard any boat, yacht or
other vessel.
INSTALLATION INSTRUCTIONS
FIG. 1
A
FIG. 1B