Zanussi ZCV550 Cooktop User Manual


 
To replace the glass panels obey the procedure in
opposite sequence. Before you lower the trim attach
the A trim part to the door. Refer to picture.
Oven lamp
Warning! There is a danger of electrical shock!
Before you change the oven lamp:
Switch off the oven.
Remove the fuses in the fuse box or switch off the cir-
cuit breaker.
Put a cloth on the bottom of the oven for protection
of the oven light and glass cover.
Replacing the oven lamp
1. You can find the lamp glass cover at the back of the
cavity.
Turn the lamp glass cover counterclockwise to re-
move it.
2. Clean the glass cover.
3. Replace the oven lamp with applicable 300°C heat-
resistant oven lamp.
Important! Use the same oven lamp type.
4. Install the glass cover.
What to do if…
Warning! Refer to "Safety information" chapter.
Problem Possible cause Remedy
The hob does not operate The heat setting is not set Set the heat setting
The oven does not heat up The oven is not switched on Switch on the oven
The oven does not heat up The clock is not set Set the clock
The oven does not heat up The necessary settings are not set Control the settings
The oven does not heat up The fuse in the fuse box is released Control the fuse. If the fuse is re-
leased more than one time, refer to a
qualified electrician.
The oven lamp does not operate The oven lamp is defective Replace the oven lamp
Steam and condensation settle on the
food and in the oven cavity
You left the dish in the oven for too
long
Do not leave the dishes in the oven
for longer than 15-20 minutes after
the cooking process ends
The display shows “12.00” A power cut Reset the clock
The residual heat indicator does not
come on
The cooking zone is not hot because
it operated only for a short time.
If the cooking zone must be hot,
speak to the Service Centre.
If you cannot find a solution to the problem yourself, con-
tact your dealer or the service centre.
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
17