Filter
Top Products
Installation
Important! First read "Safety information" chapter
carefully.
Technical Data
Dimensions
Height 900 mm
Width 550 mm
Depth 600 mm
Top oven capacity 37 l
Main oven capacity 74 l
Location of the appliance
You can install your freestanding appliance with cabinets
on one or two sides and in the corner.
A
A
B
Minimum distances
Dimension mm
A 2
B 685
Levelling
Use small feet on the bottom of appliance to set same lev-
el of cooker top surface with other surfaces
• Appliance left the factory fully packaged. If it is deliv-
ered without packaging and damage has occurred, the
manufacturer cannot accept responsibility. Contact
your supplier for advice.
• Do not move the appliance by hand after removed the
packaging. Do not use a sack barrow or any other aid
to lift the appliance. It can cause a damage.
• To move the appliance, open the oven door and lift the
appliance by holding inside the top of the component.
• You can fit your freestanding appliance with cabinets
on one or both sides and in the corner.
• Protect sidewalls above the hob level by heat resistant
noncombustible material and provide minimum 40 mm
distance from the sidewalls to the hob side.
• Provide minimum 2 mm air gap at either side of the
appliance to enable moving it into position.
• Surfaces above the hob (also cooker hoods) must be a
minimum of 685 mm above the hob.
Electrical installation
Warning! Only a qualified and competent person
must do the electrical installation.
The manufacturer is not responsible if you do not
follow safety precautions from the chapter "Safety
information".
This appliance is supplied without a main plug or a main
cable.
Covering terminal board
The recommended cross-section area is six square milli-
metres (6 mm²).
When you refit the mains terminal cover, make sure that
the lower tabs are located inside the bottom edge of the
aperture, before you fix the two screws into the top edge of
the mains terminal cover.
18