Zanussi ZDC 888 Oven User Manual


 
16
Something not working
SYMPTOM
n The oven does not come on
n The oven temperature light does not come on
n The oven light does not come on
n It takes too much time to finish the dishes, or
they are cooked too fast.
n Steam and condensation settle on the food
and the oven cavity.
n The timer does not work
n The oven fan is noisy
SOLUTION
u Check the oven is in manual operation and
that both a cooking function and temperature
have been selected.
u Check the oven is wired in properly, and the
socket switch or the switch from the mains
supply to the oven are ON.
u Select a temperature with the thermostat
control knob
u Select a function with the oven function
control knob.
u Select a function with the oven function
control knob
u Check the light bulb, and replace it if
necessary (see "Replacing the Oven Light")
u The temperature may need adjusting
u Refer to the contents of this booklet,
especially to the chapter Using the Oven.
u Leave dishes inside the oven no longer than
15-20 minutes after the cooking is completed.
u Check the instructions for the timer.
u Check the grease filter is correctly fitted.
u Check that shelves and bakeware are not
vibrating in contact with the oven back panel.
If the oven is not working correctly, please carry out the following checks, before contacting your local
Zanussi Service Centre.
IMPORTANT:
If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use
or installation, a charge will be made even if the appliance is under guarantee.
If after all these checks, the oven still does not work,
contact your local Service Force Centre.
When you contact them, they will need the following
information:
1. Your name, address and post code.
2. Your telephone number
3. Clear and concise details of the fault
4. The model and the serial number (which can be
found on the rating plate)
5. Date of purchase
Please note that it will be necessary to provide
proof of purchase for any in-guarantee service
calls.
In-guarantee customers should ensure that
the above checks have been made as the
engineer will make a charge if the fault is not a
mechanical or electrical breakdown.