Filter
Top Products
23
WARNING!
Multi-way plugs, connectors and extension
cables must not be used. This could constitute
a fire hazard through overheating.
If necessary, have the domestic wiring system
socket replaced. In case that the electrical
cable has to be replaced, contact your local
Service Force centre.
The plug must be accessible after the
appliance has been installed.
Never unplug the appliance by pulling on the
cable. Always pull the plug.
WARNING!
Safety standards require the appliance to be
earthed. The manufacturer accepts no liability
for failure to observe the above safety
precautions.
Prior to using the appliance for the first time,
ensure that the rated voltage and type of
supply on the rating plate match that of the
supply where the appliance is to be installed.
The fuse rating is also to be found on the rating
plate.
Always plug the mains plug into a correctly
installed shockproof socket.
Electrical connection
Fitting under a counter
By removing the dishwasher’s worktop, you can
install it under a close fitting sink unit or a pre-
existing top.
Be sure that once the appliance has been
installed, it is easily accessible for the service
engineer in the event that a repair is required.
Unscrew the two screws
at the rear.
Push the top backwards
about 1 cm.
Lift top at the front and
remove it.
Check if the dishwasher
is levelled.
If not, loosen or tighten
the adjustable feet until
the appliance is
perfectly levelled.
Levelling
Good levelling is essential for correct
closure and sealing of the door.
When the appliance is correctly levelled,
the door will not catch on either side of the
cabinet.
156999480en.qxp 3/2/2006 8:11 AM Pagina 23