Filter
Top Products
9
Setting the water softener electronically (see table)
The water softener is factory set at position 5.
The dishwasher must
be switched off.
Switch on the
dishwasher by pressing
the On/Off button.
To change the level,
press function button 1.
Each time the button is
pressed the level
increases. (Level 1
follows level 10).
The End of
programme light might
flash 5 times, for
example. The flashing is
repeated every 5
seconds.
The End of
programme light
indicates the new
setting. (For the
selection of the new
level see the chart).
To memorise the
operation, switch off the
dishwasher by pressing
the On/Off button.
Press and hold
simultaneously function
buttons 2 and 3 until the
lights of function
buttons 1, 2 and 3 start
flashing.
Release the buttons and then press function button
1; the lights of function buttons 2 and 3 turn off while
function button 1 goes on flashing. At the same time
End of programme light starts to flash.
The number of flashes of the End of programme
light corresponds to the current level.
156999480en.qxp 3/2/2006 8:11 AM Pagina 9