Filter
Top Products
9
Setting the water softener electronically (see table)
Release the button. The END indicator light will
flash. The number of flashes corresponds to current
level set.
The END indicator light might flash 5 times, for
example. The flashing is repeated every 5 seconds.
To change the level, press the start/cancel button.
Each time the button is pressed the level increases.
(Level 1 follows level 10).
The END indicator light indicates the new setting.
To memorise the operation, turn the programme
selector dial to position off.
Press and hold the start/cancel button and turn the
programme selector dial clockwise till the first
programme.
Keep the button pressed until the programme On/off
indicator light and the start/cancel indicator light
start flashing.
The water softener is factory set at position 5.
The dishwasher must be switched off
Filling with dishwasher salt
Unscrew the cap. Only before filling with
salt for the first time,
fill the salt container
with water
Using the funnel
provided, pour in the
salt until the container is
full.
CAUTION!
Use only special salt suitable for dishwashers
156998720en.qxp 1/31/2007 4:22 PM Page 9