Filter
Top Products
caused by inappropriate waste handling of this
product. For more detailed information about
recycling of this product, please contact your
local city office, your household waste disposal
service or the shop where you purchased the
product.
Something not working
The dishwasher will not start or stops during
operation. Certain problems are due to the lack
of simple maintenance or oversights, which can
be solved with the help of the indications de-
scribed in the chart, without calling out an
engineer.
Switch off the dishwasher, open the door and
carry out the following suggested corrective ac-
tions.
Fault code and malfunction Possible cause and solution
The dishwasher does not fill with water.
•
continuous flashing of the light of the running
programme
• 1 flash of the "End of programme" light
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the threaded hose fit-
ting at the water inlet valve is blocked.
Clean the filter in the threaded hose fitting.
• The water inlet hose has not been correctly laid or
it is bent or squashed.
Check the water inlet hose connection.
The dishwasher will not drain.
•
continuous flashing of the light of the running
programme
• 2 flashes of the "End of programme" light
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid
or it is bent or squashed.
Check the water drain hose connection.
•
continuous flashing of the light of the running
programme
•
3 flashes of the end of programme indicator
light
• Anti-flood device is activated
Close the water tap and contact your local Service
Force Centre.
19