Filter
Top Products
6. Eco drying
By pressing this button you can opt to shorten or
completely eliminate the hot air drying cycle, so
making a considerable energy saving (Eco or No).
If programme no. 7 is selected the indicator light
"NO" will come on for default but it is possible to
change the setting by depressing this button.
With the programme no. 1 the drying options are not
available.
If both pilot lights are out, the full drying cycle will
be carried out.
7. Digital display
8. Delay start button
Allows the start of the programme to be delayed by a
minimum of 1 hour, up to 9 hours.
How to set the "Delay start":
- When the button is pressed, the number 1 followed
by the letter H appears in the display. This means
that you have delayed the start of the programme
by 1 hour.
- Press the button again to select the number of
hours by which you wish to delay the programme
start, up to a maximum of 9.
- The delay start will not modify the settings made
previously.
Close the dishwasher door and press the start button
(if the start button is pressed with the door open the
door indicator light will flash). All the phase indicator
lights are off.
The countdown will begin and the display will
indicate with step of 1 hour how much longer there is
to go before the beginning of the programme. The
letter H on the display will flash indicating the delay
is operating.
If you wish to cancel the delay start, press the start
button until you see two zeros in the digital display.
9. Start pushbutton
This is the last button to be pressed after setting the
wash programme and, if required, drying options, half
load, delayed start.
This button starts the programme. On the digital
display you can read the approximate duration in
minutes of the programme and, as it proceeds, how
much longer there is to go before the end of the
programme in steps of 5 minutes.
At 10 minutes from the end of the programme the
steps will be in steps of 1 minute.
At the end of the programme in the digital display
will appear due zeros.
To cancel or change a programme
You are able to cancel or change a programme with
the door open or closed.
If you wish to cancel/change a programme which is
already running or a setting which has just been made,
press the start button until due zeros appear in the
digital display and the indicator lights (except the
On/OFF indicator light) turn off.
Now a new programme and new options may be
selected.
10. Programme phase
indicator lights
As soon as you select a washing programme, this
illuminates all the phases the programme consists of.
As the programme progresses, the wash cycle phase
in progress will illuminate.
At the end of the programme the phase indicator
lights turn off.
Prewash/Rinse and Hold
Wash
Rinse
Hot air drying
6
PCP18UK