Filter
Top Products
4
CONSERVATION
In the interests of the Environment:
When disposing of your old fridge, freezer or fridge/
freezer.
Help to keep your country tidy – use authorised
disposal sites for your old appliances.
For maximum efficiency:
Make sure that the appliance is cleaned properly.
Make sure that the door is closed properly.
Do not position the appliance near to sources of
heat.
Do not over-fill your appliance, air MUST be
allowed to circulate.
INSTALLATION
Warning
IF YOU ARE DISCARDING AN OLD
APPLIANCE THAT HAS A LOCK OR CATCH
ON THE DOOR, YOU MUST ENSURE THAT IT
IS MADE UNUSABLE TO PREVENT YOUNG
CHILDREN BEING TRAPPED INSIDE.
Depending upon the position you choose for your
appliance, you may wish to reverse the way in which
the door opens. To do this, refer to instructions on
“Door reversal directions” paragraph.
Positioning
This appliance is designed to operate in ambient
temperatures between 10
°
C (50
°
F) and 32
°
C (90
°
F).
It should be located in a dry atmosphere, out of direct
sunlight and away from extreme temperature e.g.
not next to a cooker or other sources of direct heat,
or in a very cold room e.g. an outhouse, where the
temperatures may fall below 10
°
C (50
°
F). If these
temperatures are exceeded i.e. colder or warmer,
then the appliance may not operate correctly.
You should also ensure that air can circulate freely
around the back and the top of the cabinet. There must
also be at least 100 mm (4”) distance between the top of
the cabinet and any overhanging kitchen furniture
(Fig. 1-A). Ideally, the appliance should not be
positioned beneath overhanging furniture (Fig. 1-B).
Fig. 1
There should also be a gap of 25 mm either side of
the appliance. Do not obstruct the space
underneath. The back of the cabinet may be placed
close to the wall but must not touch it. DO NOT
A
B
NP005
100 mm 10 mm
10 mm
install in places with restricted ventilation.
Adjust the level of the appliance by screwing out
the adjustable foot, or feet, at the bottom of the
cabinet using your fingers or a spanner (see Fig. 2).
Fig. 2
Before using
Remove all securing tapes. Wash inside the appliance
with lukewarm water and a little bicarbonate of soda
(one teaspoonful to one quart of water). Do not use
soap or detergent as the smell might linger. Dry
thoroughly.
Rear spacers
The plastic bag containing all relevant
documentation also contains two spacers to be fitted
into special holes in the back of the appliance.
Fit the spacers into the holes, taking care to ensure
that the arrow (A) is positioned as shown in Fig. 2a.
Then turn them through 45
°
(arrow (A) vertical)
until they lock into place.
Fig. 2a
D200
D060
A
45°