Filter
Top Products
11
INSTALLING THE COOKER HOOD
Please ensure that when the appliance is installed
it is easily accessible to an engineer in the event of
a breakdown.
All installations must comply with the local
authorities requirements for the discharge of
exhaust air.
Incorrect installation may affect the safety of this
cooker hood.
Installation Requirements
Before installation check the wall to which the
cooker hood is to be fi tted for electric cables,
water pipes or gas.
This cooker hood is designed to be fi xed to any vertical
surface over a cooking area, and can be used in the
extraction (ducted to the outside) or recirculation mode.
The installation work must be undertaken by a qualifi ed
and competent person.
The manufacturer disclaims any responsibility for
damage due to incorrect installation of the cooker hood
or if the hood is not installed in compliance with relevant
regulations controlling this type of installation.
Unpacking
Before unpacking the cooker hood position
the carton with the arrows pointing upwards as
illustrated on the carton.
The cooker hood is made up of the following
components:
Ref Qty Product Components
1 1 Hood body, complete with controls,
lighting, fan and fi lters.
2 1 Telescopic Chimney comprising:
2.1 1 Upper section
2.2 1 Lower section
9 1 ø150-120 Ducting spigot
10 1 ø120-125 Ducting fl ange
15 1 Air outlet connector
Ref
Qty Installation Components
7.1 2 Hood body fi xing brackets
7.2 2 Upper chimney wall fi xing brackets
12c 6 Chimney fi xing screws
12d 2 Screws M4x25
Ref
Qty Documentation
1 Instruction booklet
1
9
12c
12c
12c
12d
7.2.1
15
2
2.1
2.2
7.1
10