Filter
Top Products
13
Fitting the Wall Brackets
• Draw a vertical line on the supporting wall up to the
ceiling, or as high as practical, at the centre of the area
in which the hood will be installed.
• Draw a horizontal line at 650 mm above the hob for
installation without the back panel, or at height H
(H=height of the visible part of the panel) for instal-
lation with the back panel.
• Place bracket 7.2.1 on the wall as shown about 1-2
mm from the ceiling or upper limit aligning the centre
(notch) with the vertical reference line.
• Mark the wall at the centres of the holes in the
bracket.
• Place bracket 7.2.1 on the wall as shown at X mm
below the fi rst bracket (X = height of the upper chimney
section supplied), aligning the centre (notch) with the
vertical line.
• Mark the wall at the centres of the holes in the
bracket.
• Place bracket 7.1 as shown 95 mm from the verti-
cal reference line and 210 mm above the horizontal
reference line.
• Mark the centres of the holes in the bracket.
• Repeat this operation on the other side.
REAR PANEL (OPTIONAL)
The Rear Panel must be fi tted before fi xing the hood body
and, if it is to be fi xed at both top and bottom, must be
fi tted at the correct height prior to installing the bases.
As this operation is rather complex, it should be carried
out either by the kitchen installer or a qualifi ed person
who knows the fi nal dimensions of the units.
For fi xing at the top only, proceed as follows:
• Rest the back panel on the base, inserting the lower
plate between the upper surface and the wall, centring
it on the vertical reference line.
• Mark the centres of the two holes in the upper plate.
• Drill ø 8 mm holes at all the centre points marked.
• Insert the wall plugs (not supplied) in the holes.
• Fix the brackets using the screws (not supplied).
• Fix the back panel (where present) using the screws
(not supplied).
Note: If the hood is to be installed onto a hollow con-
struction or plaster or partition board wall then special
fi xing screws will be required (not supplied).
Fitting the Canopy Hood
• Screw the two screws item 12d supplied onto the
brackets 7.1.
• Hook the hood body onto the bracket 7.1, centring
it around the vertical line.
• Use the adjusting screws item 12d underneath the
hood to level the hood body
H
X
1÷2
650 min.
7.2.1
7.1
95
95
210
7.1
12.d
INSTALLING THE COOKER HOOD