Filter
Top Products
17
MAINTENANCE AND CLEANING
Before any maintenance or cleaning work is
carried out, DISCONNECT the appliance from
the ELECTRICITY supply.
Internal cleaning
Clean the inside and accessories with warm
water and bicarbonate of soda (5ml to 0.5 litre
of water). Rinse and dry thoroughly.
NEVER USE DETERGENTS, ABRASIVE
POWDERS, HIGHLY PERFUMED
CLEANING PRODUCTS OR WAX
POLISHES, TO CLEAN THE INTERIOR
AS THESE WILL DAMAGE THE
SURFACE AND LEAVE A STRONG
SMELL.
Clean the drain hole of the water trough at
regular intervals and make sure that the drain
hole is never obstructed, so that the defrost
water may flow freely.
When the appliance is not in use
When the appliance is not in use for long
periods, disconnect from the electricity supply,
empty all foods and clean the appliance, leaving
the doors ajar to prevent unpleasant smells.
Changing the light bulb
Should the interior light fail to work, first switch
off the appliance and disconnect from the
electricity supply, then replace the bulb as
follows;
unscrew the light cover and then pull it outward
by pressing as shown in the Fig. 18. Unscrew
the bulb and replace it with a new 15 watt bulb
(available from your nearest Zanussi Service
Force Centre).
Replace the light cover by sliding it into its
original position and replacing the screw.
GB
D411
Fig. 18