Care and cleaning
Warning! Refer to "Safety information" chapter.
• Clean the front of the appliance with a soft cloth with
warm water and cleaning agent.
• To clean metal surfaces use a usual cleaning agent
• Clean the oven interior after each use. Thus you can re-
move dirt more easily and it does not burn on.
• Clean stubborn dirt with a special oven cleaner.
• Clean all oven accessories (with a soft cloth with warm
water and cleaning agent) after each use and let them
dry.
• If you have nonstick accessories, do not clean them
using an aggressive agents, sharp edged objects or
dishwasher. It can destroy nonstick coating!
Stainless steel or aluminium appliances:
Clean the oven door with a wet sponge only. Dry it
with a soft cloth.
Do not use steel wool, acids or abrasive materials as they
can damage the oven surface. Clean the oven control pan-
el with the same precautions
Cleaning the door gasket
• Regularly do a check of the door gasket. The door gas-
ket is around the frame of the oven cavity. Do not use
the appliance if the door gasket is damaged. Contact
the Service Centre.
• To clean the door gasket refer to the general informa-
tion about the cleaning.
Oven lamp
Warning! Be careful! There is the risk of electrical
shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch off the cir-
cuit breaker.
Put a cloth on the bottom of the oven for protection
of the oven light and glass cover.
1. Turn the glass cover anti-clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with applicable 300°C
heat-resistant oven light bulb.
Use the same oven lamp type.
4. Install the glass cover.
Cleaning the oven door
The oven door has two panels of glass. You can remove
the oven door and the internal panel of glass to clean it.
The oven door can close if you try to remove the in-
ternal panel of glass before you remove the oven
door.
1
Open the door fully
and hold the two door
hinges.
2
Lift and turn the levers
on the two hinges.
3
Close the oven door to
the first opening position
(halfway). Then pull for-
ward and remove the door
from its seat.
4
Put the door on a soft
cloth on a stable surface.
5
Release the locking
system to remove the in-
ternal panel of glass.
90°
6
Turn the two fasteners
by 90° and remove them
from their seats.
10