Zanussi ZOB 1060 Oven User Manual


 
11
"Fast Heat Up" function
After a cooking function has been selected and the
temperature has been adjusted, the cavity will gradually
heat up until the selected temperature is reached. This
will take from 10 to 15 minutes, depending on selected
function and temperature.
If it is necessary to reach the required temperature in a
shorter time, the "Fast Heat Up" Function can be used.
1) Switch the oven on by pressing button .
2) Set the required cooking function and temperature as
explained in the previous pages.
3) Set the temperature by pressing button
or
“.
The temperature will appear on the display.
4) Press button
B
. The temperature display will show
"FHU" (Fig. 18).
5) press button
and the symbol
°
will flash for
approximately 10 seconds. Now it is possible to
select the required temperature by pressing button
or
“.
4) When the required temperature is reached, an
acoustic alarm will sound for a short time, and the
temperature display will revert to the set temperature.
This function can be used with any cooking function or
temperature.
Demo mode
This mode is intended to be used in the shops to dem-
onstrate the oven functionality without any power con-
sumption except the oven lamp. To activate this func-
tion the appliance should be in stand-by mode.
Press button
B
and
for approximately 2 sec-
onds (Fig. 19).
An acoustic alarm will sound for a
short time
.
Press button and the “
id
” indication will appear
in the display.
All oven functions can be selected.
The thermometer symbol
will not flash anymore
and “
id
” indication will be replaced by number dig-
its.
Follow the above described procedure to disable
the demo mode.
Error code
The electronic programmer does a continuous diagnostic
check of the system. If some parameters are not cor-
rect, the control unit will stop the activated functions
and it will show on the display the corresponding error
code (Fig. 20).
For further details, refer to chapter "Something not work-
ing“ on page 20.
B
Fig. 18
B
Fig. 19
B
Fig. 20