Zanussi ZPB 1260 Oven User Manual


 
16
How to use the pyrolytic cleaning
function
Before activating the pyrolytic cleaning function,
remove any excessive spillage and make sure
that the oven is empty. Do not leave anything
inside it (e.g. pans, grids, baking tray, dripping
pan, etc.) as this could heavily damage them.
Ensure that the oven door is closed before
activating the pyrolytic cleaning function.
When the pyrolytic cleaning function is on, it is
advisable not to use the hob as this could cause
overheating and damage the appliance.
During the pyrolytic cleaning cycle the oven door
becomes hot. Children should be kept away until
it has cooled.
Choose this function to clean the oven by pyrolysis.
The following pyro levels are available:
Pyrolytic 1 (P I) time : 2 h = 30 min heat-up +1 h at
480°C + 30 min cooling down.
Pyrolytic 2 (P 2) time : 2 h 30 min. = 30 min heat-up +1
h 30 min at 480°C + 30 min cooling down.
The pyro duration time cannot be changed.
To activate the pyrolytic cleaning function proceed as
follows:
1. Press button
to switch on the oven. Press the
button as often as necessary, until the “Pyro“
function symbol (level 1 - P I) will appear on the
display (Fig. 18).
2. The Cooking Duration symbol will flash for 5
seconds; during this time push ' ' or ' ' buttons to
select the pyrolytic 1 (P I) or pyrolytic 2 (P 2) function
(Fig. 19).
3. Once you have chosen the desired pyrolytic function,
the “Pyro” writing will flash on the display waiting for
confirmation to start the pyro cleaning function . If
' ' or ' ' buttons are pushed, the Cooking Duration
symbol will flash again to allow you to change
the pyro selection (P I or P 2) (Fig. 19).
4. To confirm which pyrolytic function you desire, press
button , the “Pyro” text will stop flashing and the
pyrolytic cleaning cycle starts (Fig. 20).
5. After some time, the door lock will be activated and
the related symbol will be displayed (Fig. 21). At
this time the button is no more active.
At the end of the pyrolitic cleaning process, the display
shows the time of day. The oven door is locked.
Once the oven has cooled down, an acoustic signal will
be emitted and the door will unlock.
To stop the pyrolytic cleaning cycle at any time, press
button .
NOTE: The time indication is comprehensive of the
cooling down time.
Fig. 18
Fig. 19
Fig. 20
Fig. 21
If you select a cooking function while the pyrolytic
function is active, the cleaning cycle will be inter-
rupted.
If the oven door lock is activated, it is impossible
to select any cooking function until the door lock
is off.