Filter
Top Products
10
Setting electronically:
1.Press the ON/OFF button.
3 If indicators for the programme buttons are lit,
a dishwashing cycle is activated. The dish-
washing cycle must be deselected:
Press function buttons 1 and 2 simultaneously
for approx. 2 seconds.
All additional wash programme button indica-
tors will go out.
2.Press function buttons 1 and 2 simultaneously and
keep them pressed.
The LED indicators for function buttons 1 to 3 will
flash.
3.Press function button 1.
The LED indicator for function button 1 will flash.
The multi-display will indicate the hardness setting.
4.Pressing function button 1 increases the hard-
ness setting by 1.
(Exception: hardness setting 1 follows hardness
setting 10).
5.When the hardness setting is correct, press the
ON/OFF button.
The hardness setting is now saved.
If the water softener is set electronically to “1”, this
switches off the control indicator for dishwasher salt.
Water hardness Adjusting the hardness setting
Indication on the
multi-display
in °d
1)
in mmol/l
2)
Range Manual Electronic
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
9,0 - 12,5
7,6 - 8,9
6,5 - 7,5
5,1 - 6,4
4,0 - 5,0
IV 1
10
3)
9
8
7
6
10L .
9L
8L
7L
6L
0*
19 - 22
15 - 18
3,3 - 3,9
2,6 - 3,2
III
5
4*
5L
4L
11 - 14 1,9 - 2,5 II 3 3L
4 - 10 0,7 - 1,8 I/II 2 2L
below 4 below 0.7 I
1
no salt necessary
1L
1) (°d) German degree, measure of the hardness of water
2) [mmol/l] millimol per litre, international unit for water hardness
3) On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting