Filter
Top Products
www.zephyronline.com
10
Features & Controls - Touch Controls & Features
The standard Metal Filters are required to be cleaned frequently and as recommended in order to maintain blower
eciency. If improperly maintained, residue from cooking will sift though lters and cause damage to hood blowers
and other sensitive components; and possibly clog duct work and create a re hazard.
1. Blower On/O
By pressing , the blower is switched On and O. When switched on, the blower starts up on speed level 3.
2. Speed Selection
The 6 speed levels are selected by presing to decrease and to increase speed level. The display indicates
level selected.
3. Delay O
This is used for programmed shut down of blower and lights 15 minutes after the function is activated. Press once,
a dot ashes in the lower right hand side of display indicating the function is on. The hood will completely shut down
in 15 minutes.
4. Lights On/O/Dim
Switch lights On and O by pressing key once. To dim lights, press and hold for 2 seconds.
5. Advance Display Functions
Filters Clean Reminder (Metal):
After every 30 hours of use, the display will start ashing an reminding you to clean the metal lters from residue and
possible clogs.
Filters Change Reminder (Charcoal, if tted):
When your hood is installed as “Recirculating” (Ductless) unit, it is tted with a set of Chacoal Filters to purify any
exhaust and fumes from cooking, and re-circulates the air within the home. These Charcoal Filters are required to be replaced
after every 120 hours of use. The
Filter Change Reminder function in the microprocessor needs to be switched on. The
microprocessor in the controls when set, will elapsed and count usage time and indicate when charcoal lter replacement is
needed every 120 hrs.