4
Assembly
Model Atd-7454: (Refer to Figure 3)
Note: Do not tighten any bolts unless told to do so.
1. Attach base legs (1) to upright channels (2) with bolts,
lock washers and nuts (3). Hand tighten only.
2. Attach lower cross member (4) to upright channels
(2) with bolts, lock washers and nuts (3).
3. Attach support links (5) to the base (1) and upright
channels (2) with bolts, lock washers and nuts (3).
4. Carefully slide bed frame (6) down to lowest possible
position between the upright channels (2).
5. Attach the screw hooks (7) to the jack bracket (8)
with nuts (9). Leave nut untighten to provide easier
spring attachment later.
6. Slide the jack bracket (8) down between upright
channels (2) onto the bed frame (6).
7. Attach upper cross members (10) to upright channels
(2) with bolts, at washers, lock washers and nuts
(11).
8. Attach head plate (12) to upper cross members (10)
with bolts, lock washers and square washers (13).
9. Attach two bolts, lock washers and nuts (14) thru the
upper cross member (10). Then attach one end of
the springs (15) to the bolts (14) and the other end
to the screw hooks (7) on the jack bracket.
10. Carefully place the bottle jack (16) between the
head plate (12) and jack bracket (8). Tighten the
nuts (9) that hold screw hooks (7) to prevent jack
from inadvertently falling out.
11.Tighten all applicable nuts and bolt
assemblies.
12. Carefully bring the bed frame (6) up and secure it
with pins (19).
13. Place the Arbor Plates (17) on Bed Frame (6).
14.The press is now ready to use. Don’t forget to insert
the handle (18) into handle sleeve of bottle jack
NOTICE: Before disassembly, carefully slide bed to
its fully lowered position.
Figure 3 - Assembly Illustration for model Atd-7454
1
4
2
3
5
6
17
18
19
7
15
10
11
16
12
8
9
3
14
13
Size of Hardware Kits Qty
3 bolt M10x25 12
lock washer M10 12
nut M10 12
9 nut M8 2
11 bolt M16x150 4
at washer M16 8
lock washer M16 4
nut M16 4
13 bolt M10x25 4
lock washer M10 4
square washer M10 4
14 bolt M10x130 2
lock washer M10 2
nut M10 2
