5
Assembly
Models Atd-7455: (Refer to Figure 5)
Note: Do not tighten any bolts unless told to do so.
1. Attach base legs (1) to upright channels (2) with bolts, lock washers and nuts (3). Hand tighten only.
2. Attach lower cross member (4) to upright channels (2) with bolts, lock washers and nuts (3).
3. Attach support links (5) to the base (1) and upright channels (2) with bolts, lock washers and nuts (3).
4. Carefully slide bed frame (6) down to lowest possible position between the upright channels (2).
5. Slide head plate (7) to into upper cross members (8). Then, secure with bolts (9).
6. Attach the upper cross members assembly (8) to the upright channels (2) with bolts, at washers, lock washers
and nuts (10).
7. Thread the ram (11) to head plate (7) on upper cross members (8).
8. Attached pump support bracket (12) to upright channel (2) with three bolts, lock washers and nuts (3).
9. Tighten all aplicable nuts and bolt assemblies.
10. Place the hand pump (13) on pump support bracket (12).
11. To hold the pump, attach the xed backets (14) and secure with bolts, lock washers and nuts (3).
12. Connect the male coupler end of hydraulic hose (15) to the female coupler of the ram (11) to complete the
connections.
Figure 5 - Assembly Illustration for model Atd-7455
3
4
18
15
11
9
7
13
3
14
12
2
1
3
5
3
16
6
10
17
8
Size of Hardware Kits Qty
3 bolt M10x25 19
lock washer
M10 19
nut M10 19
9 bolt 10x25 2
10 bolt M16x150 4
at washer M16 8
lock washer
M16 4
nut M16 4
13. Carefully bring the bed frame (6) up and secure it
with pins (16).
14. Place the Arbor Plates (17) on Bed Frame (6).
15 When necessary, replace the saddle of ram (11) with
the bearing punch (18).
16.The press is now ready to use.
NOTICE: Before disassembly, carefully slide bed to
its fully lowered position.
Figure 4 - Shop Press Components (Atd-7455 shown)
Bed Frame
Arbor Plate
Lower Cross Member
Upper Cross Member
Pump Handle
Base Leg
Hydraulic Couplers (1/4" NPT)
Hydraulic Hose
Support Pin
Support Link
Upright Channel
Bearing Punch
Oil Filler Screw
Hand Pump
Release Valve
Pump Bracket
Ram
