4-16
Cisco 7200 VXR Installation and Configuration Guide
OL-5013-09
Chapter 4 Observing System Startup and Performing a Basic Configuration
Using show Commands to Check the Installation
• Loading configuration files or system images using remote copy protocol (rcp) or Trivial File
Transfer Protocol (TFTP)
• Reloading the operating system
Using show Commands to Check the Installation
Use show commands to identify the hardware installed in your router, to verify the operation status, to
view interface configuration settings, and to troubleshoot your router configuration. The interfaces on
the NPE-G1 or NPE-G2 are identified by their chassis slot number and interface port number (slot/port).
The interfaces on your I/O controller are also identified by chassis slot number and interface port number
(slot/port). The chassis slot number for the I/O controller is always slot0.
Table 4-1 lists the NPE-G,
NPE-G2, and the I/O controller models, their corresponding interfaces, and the interface addressing
syntax for each interface.
Tab le 4-1 Identifying Interface Addresses on the NPE-G1, NPE-G2 and Various I/O Controllers
Model Interface Numbers Syntax
NPE-G1 or NPE-G2 Gigabit Ethernet (port 0/1)
1
Gigabit Ethernet (port 0/2)
Gigabit Ethernet (port 0/3)
1. Both optical and copper ports report the same syntax. For example, Gigabit Ethernet RJ-45 port 0/2 reports GigabitEthernet 0/2, as does Gigabit Ethernet
GBIC port 0/2.
Chassis slot—always 0
Interface port—1, 2, or 3
Gigabit Ethernet 0/1
Gigabit Ethernet 0/2
Gigabit Ethernet 0/3
C7200-I/0-GE+E Gigabit Ethernet (port GE0) Chassis slot—always 0
Interface port—0
gigabitethernet 0/0
Ethernet (port E0) Chassis slot—always 0
Interface port—0
fastethernet 0/0
C7200-I/0-2FE/E Fast Ethernet/Ethernet (port0) Chassis slot—always 0
Interface port—0
fastethernet 0/0
Fast Ethernet/Ethernet (port1) Chassis slot—always 0
Interface port—1
fastethernet 0/1
C7200-I/0-FE
2
2. The Product Number C7200-I/O-FE does not specify MII because both an MII and an RJ-45 receptacle are included.
Fast Ethernet (MII or RJ-45) Chassis slot—always 0
Interface port—0
fastethernet 0/0
C7200-I/0 No interface ports — —
C7200-I/0-FE-MII
3
3. The I/O controller with the Product Number C7200-I/O-FE-MII has a single MII FastEthernet receptacle only. Although still supported by Cisco Systems,
this I/O controller with a single MII receptacle is no longer an orderable product as of May 1998.
Fast Ethernet (MII) Chassis slot—always 0
Interface port—0
fastethernet 0/0
