A SERVICE OF

logo

SW DVI A Series • Installation
Installation, cont’d
2-6
SW DVI A Series • Installation
2-7
Furniture mounting
To mount the SW DVI A switcher under a desk, table, or
podium, use the optional VersaTools MBU 123 Mini Under-Desk
Mounting Kit (part #70-212-01), as follows:
1. If rubber feet were previously attached to the bottom of the
unit, remove them.
2. Remove the two screws from one side of the SW2/SW4.
Retain the screws for possible later reassembly.
3. Attach one bracket to the side of the unit, using the
provided machine screws.
Preparing the SW2/SW4 for under-desk mounting
4. Repeat steps 2 and 3 on the other side of the SW2/SW4.
5. Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the brackets’ screw holes.
6. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep, into the mounting surface at the marked screw
locations.
7. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than 1/4" of the screw head protrudes.
8. Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
9. Slide the unit slightly forward or back, then tighten all four
screws to secure it in place.
Attaching the back of the rack mounting brackets to
the SW2/SW4 switcher
4. Repeat steps 2 and 3 on the other side of the unit.
5. Mount the switcher to the rack support, using the two
included rack screws.
MAV SERIES
AV MATRIX SWITCHER
I/O
AUD
AUDIO SETUP
PRESET
VID
IR
+dB
-dB
ENTER
2
7
6
5
2
4
1
INPUTS
OUTPUTS
8
3
1
8
6
5
4
3
7
Mounting the SW2/SW4 to a back of the rack support