A SERVICE OF

logo

SW DVI A Series • Installation
Installation, cont’d
2-14
SW DVI A Series
To enable autoswitching,
1. Cut a small piece of wire to use as a jumper.
2. Insert the ends of the wire into pin holes 4
and 5 of the provided 5-pole captive screw
plug, connecting pins 4 and 5 together. (See
the gure at right.)
3. Use an Extron Tweeker or other small
screwdriver to tighten the plug’s two screws
above pin slots 4 and 5, so that the jumper
wire ends remain securely in place.
4. Insert the plug into the 5-pole captive screw
connector on the SW2/SW4 rear panel.
0.4A MAX
12V
POWER
+
INPUTS
INPUTS
OUTPUT
1
1
OUTPUT
REMOTE / AUTO - SW
2
3
2
4
Remote/Auto-Sw connector with pins 4 and 5
connected by a jumper
Autoswitching remains in effect as long as the jumper wires are
connecting the two pins together.
3
Chapter Three
Operation
Front Panel Features
Operations
Updating Firmware