1-3
Installing the Hub
Installing and Configuring Your Hub
Installing the Hub
1. Plug the power cord into the hub’s power cord receptacle and into an AC
(alternating current) power source. If you are using an RPS as your
primary power source, refer to the Cisco RPS User Guide for specific
instructions.
Note If your RPS is the primary power source for the hub, disconnect the AC power
cord connected directly to the hub for proper operation.
Note The hub does not have a power switch; it is powered on when the power cord
is plugged in. HP recommends that you only use one power source at a given
time.
If not connecting a Redundant Power Supply,
connect included power cord here and to an
alternating current power source.
(Optional) Connect Redundant Power Supply connector
cord clip here.
MUCHO.BK : ch1.fm5 Page 3 Thursday, June 26, 1997 11:37 AM
