8
166240008
3/17/95
Also check to see if the float valve is functioning properly and the correct water level is being maintained. Adjust
if necessary.
2. Check the refrigerant circuit by making sure that the condenser fan is running. (This will be evident by air
noise) Is the compressor running? (Feel the casing for vibration). Is the evaporator getting cold?
3. Check bin--harvest switch operation. )See procedure in manual).
ILL025
WATER
DISTRIBUTOR
HOLES
INSTALLATION INSTRUCTIONS FOR MOUNTING ON DRINK DISPENSERS
For mounting ice machine on to an ice/drink dispenser you should have the proper install kit.
Checkout Procedure For Harvest Bin Switches
Turn on the ice machine and move the evaporator curtain(s) away from the evaporator(s). The ice machine
should then shut--off in approximately 10 seconds. (See detail A & B).
Slowly let the evaporator curtain(s) move back toward the evaporator(s) until the bottom edge of the curtain(s)
is at least at the bent edge of the water reservoir or closer to the evaporator. With the curtain(s) at that position,
the machine should start. (See detail C).
DETAIL ”C”
DETAIL ”B”
DETAIL ”A”
ACORN NUT
BOTTOM
EDGE OF
EVAPORATOR
CURTAIN
SENSOR
THERMO-
WELL
PROXIMITY
SWITCH
ACORN NUT
WATER
RESERVOIR
EVAPORATOR
CURTAIN
MAGNET
CURTAIN EDGE
ill 021
Adjustment Procedure For Harvest Bin Switches.
If adjustment is necessary, loosen acorn nuts and move proximity switch closer to the curtain(s) and make sure
the curtain is properly mounted. (See detail A).
