7Top Innovations
ASSEMBLING THE
PORTABLE POWER STEAM CLEANER
CONNECTING THE JET NOZZLE
1. Align Jet Nozzle with Main Steam Nozzle as shown (FIGURE 1-A).
2. Press down on the yellow locking button located on Main Steam Nozzle. While continuing to
hold button down, slide Jet Nozzle onto Main Steam Nozzle. Push Jet Nozzle over button, and
continue to push it on unit button snaps through hole on Jet Nozzle (FIGURE
1-B).
3. To remove, press in on yellow locking button while simultaneously pulling Jet Nozzle off of
Main Steam Nozzle.
CONNECTING THE BRUSHES OR NOZZLE TIP
1. Align Brush or Nozzle Tip with Jet Nozzle as shown (FIGURE 2-A). Make sure that two side
pegs on tip of Jet Nozzle align with grooves inside of Brush or Nozzle Tip.
2. Slide Brush or Nozzle Tip onto Jet Nozzle, then rotate clockwise (when viewed from front) to
lock in place (FIGURE
2-B). Side pegs on Jet Nozzle will be visible through small holes in
Brush or Nozzle Tip (FIGURE 2-C).
FIGURE 2
FIGURE 1
B
A
C
BA
YELLOW LOCKING
BUTTON
