A SERVICE OF

logo

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33027
4.3 PEEL OFF MODULE (B-EX904-H-QM-R)
4-14
5) Align the notch of the take-up holder with the screw hole of the rewinder ass’y, and attach them to
the printer with the four M-3x6 screws and the M-3x6 screw.
6) Attach the rewind full sensor (LED) to the base with the SM-3x6 screw.
7) Fit the bush to the longer harness of the rewind full sensor (Tr) and the rewinder harness in the
orientation shown below.
Rewinder Ass’y
M3x6 Screw
Bush
Longer Harness of the Rewind
Full Sensor (Tr)
Rewinder Harness
M3x6 Screw
M3x6 Screw
Take-up Holder
Notch
Rewind Full Sensor (LED)
M-3x6 Screw
Base