6F8A0917
-
80
-
Changing the damping constant
The following is an example to show how to change the damping constant from 0.5 sec to 10 sec.
Switch operation Display example Description
D1: DAMPING
00.5 s
Select D1: DAMPING from the setting item selection menu.
The currently set damping constant (0.5 s in this example)
appears.
D1: DAMPING
00.5 s
The cursor appears.
Press
further to move the cursor to the desired digit to
change.
D1: DAMPING
1
0.5 s
10.0
s
Change the number of the digit.
To change other digit, press
under this condition to move
the cursor to that digit and change the number these.
D1: DAMPING
10.0 s
The display
links and the se
value is displayed for
confirmation.
Press
MENU/ENT
again to write the data. Then the cursor
disappears and the display returns to the condition that the
setting value is displayed.
D
1: DAMPING
Returns to the menu of setting item selection.
Note: If you set a value exceeding max value, it is forcibly changed to max value before data is
written.
