Filter
Top Products
English
11
202524A
3M
TM
Ranger
TM
Blood/Fluid and Irrigation Warming Systems
Check the 3M
TM
Ranger
TM
system website to ensure you have the most recent version of this document. www.rangerfluidwarming.com reorder #202524ACheck the 3M
TM
Ranger
TM
system website to ensure you have the most recent version of this document. www.rangerfluidwarming.com reorder #202524A
method
1. Unplug the warming unit.
2. Unfold the cleaning tool. Wet the foam
pads with a nonabrasive solution, such as
Alconox
TM
brand detergent.
3. Insert the tool from the back of the unit
and pull the tool all the way out from the
front.
4. Rinse the tool with water and repeat 3 times. Discard the tool according to institutional protocol.
5. Wipe o the unit to remove excess uid.
to clean reSiStant, dried-on FluidS:
1. Spray a nonabrasive solution inside the slot of the warming unit and let sit for 15-20 minutes.
2. Clean the unit by using the cleaning tool.
NOTE: You may use a nonmetal instrument, such as a cotton swab, to clean the upper channels. If you
are unable to adequately clean the unit, call 3M Patient Warming technical support.
StoRAge
Store all components in a cool, dry place when not in use.
Call 3M Patient Warming technical support at 800-733-7775 or 952-947-1200 for service
information.
Alconox is a trademark of Alconox, Inc.