Filter
Top Products
34
Connection instructions
Any electrical work required to install this appliance should be carried
out by a qualified electrician or competent person.
Any plumbing work required to install this appliance should be carried
out by a qualified plumber or competent person.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a drain.
Water supply connections
This dishwasher may be fed with either hot (max. 60°C) or cold water.
Nevertheless we advise a cold water supply.
A hot water supply is not always efficient with very soiled crockery as it
shortens the washing programmes.
Feeding the appliance with a hot water supply (max. 60°C) will allow you to
obtain considerably shorter programmes.
The water pressure must be within the limits given in the technical
specifications.
Your local Water Authority will advise you on the average mains pressure in
your area.
The dishwasher features fill and drain hoses which can be turned either to
the left or the right to suit the installation.
The locknut must be correctly fitted to avoid water leaks.
Avoid bends or kinks in the hose which could prevent or slow down the
water supply.
If the machine is connected to new pipes or pipes which have not been used
for a long time, you should run the water for a few minutes before
connecting the inlet hose. This will prevent
deposits of sand or rust clogging the inlet
hose filter.
For making the connection itself, the
coupling nut fitted to the machine’s
supply hose is designed to screw onto
either a 3/4" inch gas thread spout, or to a
purpose made quick-coupling tap such as
the Press-block.
CA17
152982 05/1 en 14-04-2000 11:01 Pagina 34