AEG 60860 Dishwasher User Manual


 
37
Installation and connection instructions
1 Safety Information for the Installation
Only transport the dishwasher in an upright position, otherwise salt
water may run out.
Before using the dishwasher for the first time, check for any damage
caused in transport. Do not under any circumstances connect an ap-
pliance that is damaged. In the case of damage, please contact your
supplier.
Never use the dishwasher if the mains cable, water inlet or drain hose
are damaged; or if the control panel, work top or plinth area are
damaged such that the inside of the appliance is freely accessible.
Always plug the mains plug into a correctly installed shockproof
socket.
Permanent connection: a permanent connection must only be in-
stalled by a trained electrician.
Prior to using the appliance for the first time, ensure that the rated
voltage and type of supply on the rating plate match that of the sup-
ply where the appliance is to be installed. The fuse rating is also to be
found on the rating plate.
Multi-way plugs / connectors and extension cables must not be used.
This could constitute a fire hazard through overheating.
The dishwasher’s cable must only be replaced by a Service Force Engi-
neer.
A water inlet hose with safety valve must only be replaced by a Serv-
ice Force Engineer.