Filter
Top Products
52
Adjusting the dose
According to the finish and drying results obtained,
adjust the dose of rinse aid by means of the 6
position selector (C) (position 1 minimum dosage,
position 6 maximum dosage).
Increase the dose if there are drops of water or lime
spots on the dishes after washing.
Reduce it if there are sticky whitish streaks on the
dishes.
BR02
To deactivate the rinse aid indicator light be sure that the
dishwasher is off and then proceed as follows:
1. Press INTENSIV 70° and 30 MIN programme push buttons simultaneously.
2. While keeping the programme push
buttons INTENSIV 70° and 30 MIN
pressed switch on the dishwasher by
pressing the On/Off push button.
The On/Off indicator light comes on.
At the same time, the indicator lights of
the INTENSIV 70° and 30 MIN
push buttons start flashing.
3. Press the 30 MIN push button, the
correspondent indicator light keeps
flashing while the indicator light of the
INTENSIV 70° push button turns off.
At the same time the indicator light
"end of programme" starts to flash.
4. Press the 30 MIN push button again,
the "end of programme" indicator light turns off, this means that the rinse aid
indicator light has been deactivated.
5. To memorise the operation, switch off the dishwasher by pressing the On/Off
push button.
To reactivate the rinse aid indicator light follow the same process until the "end of
programme" indicator light starts to flash.
SO449
SO451
It is possible to deactivate the rinse aid indicator light (see the following
instructions), By default the rinse aid indicator light is active.
152975 57/0 31-01-2002 9:58 Pagina 52