4. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide
5. Clean the door glass panels.
To install panels follow the procedure in re-
verse. Install the smaller panel first, then the
larger.
WHAT TO DO IF…
WARNING!
Refer to "Safety information" chapter.
Problem Possible cause Solution
The appliance does not heat up The appliance is deactivated Activate the appliance
The appliance does not heat up The time of day is not set Set the clock. Refer to "First set-
ting the time of day"
The appliance does not heat up The necessary settings are not
set
Make sure, the settings are cor-
rect
The appliance does not heat up The automatic switch-off is ac-
tivated
Refer to „Automatic switch-
off“
The appliance does not heat up The fuse is released Make sure, if the fuse is the
cause for the malfunction. If
the fuse releases again and
again, refer to an authorized
electrician
The oven lamp does not operate The oven lamp is defective Replace the oven lamp.
The display shows F102 The door lock is defect • Close the door correctly
• Deactivate the appliance
with the house fuse or the
safety switch in the fuse
box and activate it again
• If the display shows F102
again, refer to the Service
Center
The display shows an error
code that is not in this list
There is an electronic error • Deactivate the appliance
with the house fuse or the
safety switch in the fuse
box and activate it again
• If the display shows the er-
ror code again, refer to the
Service Center
If you cannot find a solution to the problem yourself, contact your dealer or the service
centre.
What to do if…
27