Filter
Top Products
Use & Care Guide
13
Freezer Features
To prevent accidental child entrapment or
suffocation risk, do not remove the divider in
the top freezer basket.
Lower Wire Basket
To Remove:
• Pull open the freezer door to full extension and lift up
and out of the door rail to remove.
To Install:
• Lower into door rail. Make sure that the basket sits
flush into place. To prevent accidental child entrapment or
suffocation risk, do not remove the divider in the freezer
basket.
Upper Wire Basket
To Remove:
• Pull upper basket out to full extension and lift out to
remove.
To Install:
• Slide upper basket into freezer. Make sure that rear of
basket hooks behind rail catch. To prevent accidental child
entrapment or suffocation risk, do not remove the divider
in the top freezer basket.
Ice and Water
Automatic Ice Maker
Note
• Energy rating guides that are posted on
the refrigerator at the time of purchase do
not include optional ice maker energy
usage.
Only 36” models come equipped with an automatic ice
maker.
Connect the ice maker to the water supply as instructed
on page 7. Proper water flow and a level refrigerator
are essential for optimal ice maker performance.
Operating Instructions
• Confirm ice bin is in place and ice maker arm is
down.
• After freezer section reaches approximately 0° F (-18°
C), ice maker fills with water and begins operating.
You will have a complete harvest of ice approximately
every three hours.
• Allow approximately 24 hours after installation to
receive first harvest of ice.
• Discard ice created within first 12 hours of operation
to assure system is flushed of impurities.
• Stop ice production by raising ice maker arm until
click is heard.
• Ice maker will remain in the off position until arm is
pushed down.
• The first one or two batches will probably contain
undersized and irregular cubes because of air in the
supply line.
• When the ice cubes are ejected it is normal for sever
al cubes to be joined together at the ends. They can
easily be broken apart. The ice maker will continue to
make ice until the supply of ice cubes raises the sen
sor arm, shutting the ice maker off .
• If bucket is not positioned properly it may prevent
automatic shut-off as ice cubes may not accumulate
to raise the sensor arm.